Messana Controls Programming

Initial setup of the project on the Messana cloud server and development of the software configuration files.

Each control unit (mBox, mZones, mSense, and mTouch) is setup and assigned a unique address and is physically labeled to be easily identified during the installation.


Detailed wiring diagrams are printed and inserted in each mBox and mZone module. The whole control system is wired and validated before shipment.

Before we can start the controls programming, you must complete the installation and programming forms that we provide. We also require an as-installed mechanical room schematic, with a complete list all the mechanical equipment (mfg #, model #, and size).

Was this article helpful?

Related Articles

Please wait

Your form is being submitted, don’t close your browser.