Back

Radiant cooling on the ceiling with Ray Magic Beams panels

Radiant cooling on the ceiling with RayMagic Beams panels (1/4″ gypsum board) cut to size to perfectly fit between ceiling joists.
The radiant gypsum panels are then covered with tongue & groove Cedar wood planks.

To improve cooling and heating performances, also a hydronic radiant floor has been installed: staple-up on the subfloor covered by the same tongue & groove Cedar wood boards directly attached on the subfloor.The house also features a NTD unit (Neutral Temperature Dehumidifier) combined with a HRV unit (Heat Recovery Ventilation) for Indoor Air Quality and comfort.
This innovative air system, specifically designed for #RadiantCooling, allows to effectively control the relative humidity throughout the small ducts of the mechanical ventilation.

The room features an ultra-modern wooden ceiling and floor that elevates the design of the  whole house interior and without compromising the comfort and ThermalWellbeing typical of a Messana radiant cooling system.

The picture shows the Cedar wood ceiling planks during installation.

Leave a Reply

Your email address will not be published. Required fields are marked *


Please wait

Your form is being submitted, don’t close your browser.